User Manual
// Simpro MegaDumper®
Original Instructions // English // v86.0 // February 2022 // Page
44
If the chains become derailed the cradle may jam when lowering as per
. If this
occurs, use a screwdriver to remove the cover-plates at the top of the mast, and realign
the chains into the correct channels on the guide plate and roller.
3.
Use lifting equipment to lie the machine onto its front (tipping) face on a wooden
pallet, and securely strap it into place.
4.
Use a 1-tonne forklift to load the pallet onto the deck of the truck.
5.
Tie the machine into position using marked tie-down points and strops rated to at
least 1000kg, ensuring it is fastened against lateral forces from any direction.
Never lie the machine onto its sides or back (safety door) as this may cause hydraulic
fluid leaks and/or damage to the guarding.
5.5
Storage
If the MegaDumper is not to be used for a period of two months or more, it should be stored
in a clean, dry place with good ventilation, at temperatures not below 0
℃
. Before placing
the machine into storage, carry out the following procedures:
1.
Clean the machine thoroughly as per
2.
Carry out two complete tipping cycles, then lower the cradle to the ground.
3.
Apply a thin layer of silicone lubricant to exposed surfaces of moving parts.
4.
Charge the batteries (if fitted) and lubricate the electrical contacts.
5.
Turn the isolator switch OFF.
6.
Remove the key and store it in a safe place.
