Simplicity AGCO Allis 400 Series, Service & Repair Manual

Page: 129 / 136

12 - 17
12 Mower Deck Repair
Mower Removal & Installation
5. Remove mower hitch (B, Figure 9) from rider hitch
brackets(C) by pulling spring-loaded lever (A) forward
and lifting up on hitch. Place mower hitch on ground.
6. With wheels turned fully left, remove mower from
underneath right-hand side of rider.
7. To install mower, reverse above steps. Check mower
belt pattern as shown in Figure 10. Make sure that
the mower lift cable is installed with hook toward the
rear and rear trailing arms (F, Figure 8) are posi-
tioned above rear torsion bar.
Figure 9. Mower Hitch
A. Lever
C. Rider Hitch Brackets
B. Mower Hitch
*2390
Figure 10. Mower Belt Pattern
A. PTO Pulley
B. Arbor Pulley (30”)
Right Arbor Pulley (34”)
C. Idler Pulley
D. Front Idler Pulley (30”)
Left Arbor Pulley (34”)
E. Idler Pulley Arm
*2392
ARBOR REPAIR
1. Remove the mower deck (see Mower Deck Removal
and Installation).
2. 34” decks only: remove the belt guard if required to
access the arbor (Figure 11).
3. Remove mower drive belt.
4. Remove mower blade on spindle to be rebuilt. See
Mower Blade Service.
Figure 11. Remove Belt Guard (34” Deck Pictured)
Belt
Guard
30” Mower
34” Mower