EN
Product range
27
The illustrations are symbolic and may deviate from the respective product.
Subject to technical modifications and errors.
9.2. Perform commissioning
In the Flamconnect app, you will be guided step-by-step through
the commissioning process.
The settings can be changed later at any time via the app.
1
Supply
controller
with power
2 Open the Flamconnect app
3
Scan
QR code
of controller
1
Label with QR Code
4 Enter connection code
2
Passkey: Input required to pair the smart device with
the controller.
5 Configuration
Follow the further steps in the app:
• Go through the checklist to ensure the conditions for operation
have been met.
• Identify actuators starting from the left
• Parameterisation of the system (operating mode heating /
cooling / both, output per room or flow rate per heating circuit)
• General settings and system balancing function
• Assignment of circuits and thermostats with input of heating
load / volume flows, cooling function, radiator thermostats.
• It is also possible to operate heating circuits without the
assignment of a room thermostat. However, this requires manual
entry of the desired power level [1 - 100 %].
1
LED:
Display of the operating statuses
2
Key to identify the actuators
After successful identification, the actuators may no longer be
exchanged with each other. If an exchange is necessary, the energy
saving controller must be restarted and the activators must be
identified and re-assigned.
6 Set / activate functions
Automatic flushing function: (see chapter on Operation)
Connect the flushing pump in the direction of flow. Flushing of the
individual circuits now takes place automatically, in series, until this
has been successfully carried out and confirmed by the operator.
(Connection to the smart device is not necessary during the whole
process)
Screed protocol function: (see chapter on Operation)
After commissioning, the screed protocol function can be activated
via the Flamconnect app.
31
QR code
1
32
QR code & passkey
Device name: 03000001
Passkey: 123456
1
2
33
Actuator
1
2
Secos
- Simplex Energy Control System
Installation instructions
|
Operating instructions
