14
6. o
PEraTing
i
nSTrucTionS
(cont.)
6.2 Polishing
a
Assemble the power tool for polishing.
s
Apply the least aggressive polish to the polishing pads.
3
Place the polishing pads face down on the test area
(usually a 2x2’ spot) of the work surface. While in the
OFF
position, move the tool around to distribute the
polish over the surface.
4
Hold the tool handle firmly by both hands and switch
tool
ON
.
5
Begin applying the polish over the work area with long
sweeping strokes in a criss-cross pattern.
6
Work the polish in, using slow overlapping movements.
7
When the polish beaks down, remove residue, check
work, repeat or go more aggressive (if needed) by using
more aggressive polish.
k
After scratches/ swirls are removed or minimized,
step down to a less aggressive polish to remove any
hazing left from the more aggressive polishes. Repeat
if necessary.
l
Once the desired finish is achieved, move on to the other
sections of the work surface.
IMPORTANT
•
Remember with polishing to BE PATIENT and learn how
the polish works and breaks down and always start with
the least aggressive pad/polish to get the job done.
•
By starting with a test section, it will allow you to see
what polish is needed without going too aggressive or
not aggressive enough to get the job done.
•
All polishes will go through stages as they break down.
Each product is different, but basically their look goes
from wet, hazing, translucent, to dry or oily. Without
going through these stages you will not get the full effect
of the polish and will most likely leave a hazed finish.
•
For more polishing details, see the instructions provided
with your polish.
Preventing burning through paint
•
It is easy to burn through the paint on a surface, especially
when working near edges or where there are abrupt changes
in the contour of the work surface. This can occur if the
polishing pads stay at one spot for a period of time.
•
To prevent burning through paint, keep the tool moving
constantly.
Proper lighting
Without proper lighting, the majority of swirls and scratches are
not visible. In addition, a lack of good lighting makes it very hard
to see the polish breaking down, especially on light coloured cars.
If possible, try to polish under controlled lighting. The sun can
sometimes be masked by clouds, haze, or fog and can hide swirls,
hazing and imperfections.
Operating Instructions
