12
5. a
SSEmbly
i
nSTrucTionS
5.1 Work Area Inspection
It is important to inspect the work area before beginning any
task to ensure no objects that could create a hazard. Remove any
objects from the work area that could be tripped over, such as toys
or outdoor furniture.
5.2 Work Surface Preparation
Before beginning task, make sure work surface is clean and dry.
Remove road tar, grease stains from the surfaces to be worked on
using a general cleaner.
5.3 Safety Advice
WARNING
Never plug the power plug (E) into an electrical outlet before
the appliance is fully assembled.
CAUTION
•
Before operation, make sure the work surface is clean
and dry. Remove road tar, grease stains, etc., from the
surfaces to be worked on using a general cleaner.
•
Let the tool run freely for no less than 1 minute before
using it for the desired application. DO NOT switch the
tool on/off while it is under load to avoid kickback or
damaging it.
•
During operation, always firmly hold on to the handle
with both hands for better control and safety.
•
When working on car bodywork, always ensure there
is no possibility of loose items left on the car, trunk or
roof. The vibration may cause the items to fall onto the
rotating disc and be thrown, leading to injury to those
in the work area.
•
DO NOT attempt to force the tool as this will cause an
uneven finish and may lead to overload and premature
motor failure.
•
Do not use a circular motion as this makes swirls. Test
before use on scrap stock.
•
Any areas inaccessible to the waxer/polisher should be
waxed/polished by hand.
5.4 Assembly Steps
A
Make sure the rocker switch is in
OFF
position.
S
Plug the unit into an outlet.
Assembly Instructions
OFF (0)
