13
5. a
SSEmbly
i
nSTrucTionS
(cont.)
5.4 Assembly Steps (cont.)
D
1. Place the polisher on its back with the three rotary discs
facing upward.
2. Attach the three waxing pads (F) or polishing pads (G)
onto rotary discs respectively.
3. Align the pad circle to the rotary disc and snugly fit it into
the rotary disc securely.
6. o
PEraTing
i
nSTrucTionS
6.1 Switching the Power Tool ON/OFF
F
1. Hold the tool handle firmly by both hands, then turn the
rocker switch to
ON
position.
2. Let the tool run for more than 3 minutes to ensure the
waxing pads (F) or polishing pads (G) snugly fits into the
rotary discs (D) before operating on the work surface.
3. Turn off the tool by putting the rocker switch to the
OFF
position.
4. Let the tool come to a full stop and place it on its back
before cleaning, maintenance or storage.
IMPORTANT
•
Make sure the polisher is in the off position before
plugging it into an appropriate electrical outlet.
•
Place the power cord (E) over your shoulder to avoid
contact with the tool head or the work surface while the
tool is running.
•
Before switching the tool on, always ensure the waxing
pads (F) or polishing pads (G) is securely attached to
the tool’s rotary disc (D). Otherwise, the waxing pads or
polishing pads may fly loose and cause personal injury or
property damage.
•
If you use the pads with drawstring, put the pads
completely over the rotary disc and pull drawstring tight,
tie bow knot and tuck the knot and all loose drawstring
completely inside the pads before turning the tool on.
Failure to do so could result in the drawstring being
caught between the motor housing and rotary disc,
increasing the risk of serious personal injury.
Assembly Instructions / Operating Instructions
ON (I)
