User manual for digital clock SWZ-W610
- Do not use the unit in explosion hazard areas.
- Do not use the unit in areas with significant temperature variations, exposed to
condensation or icing.
- Do not use the unit in areas exposed to direct sunlight.
- Make sure that the ambient temperature (e.g. inside the control box) does not
exceed the recommended values. In such cases forced cooling of the unit must
be considered (e.g. by using a ventilator).
The unit is designed for operation in an industrial environment and must
not be used in a household environment or similar.
2.
GENERAL CHARACTERISTICS
The
SWZ-W610
digital clock indicates present time, date and temperature (option) on
6-digit super-bright LED display. The reading are showed in sequence: present time (hours,
minutes and seconds), present date (day of month, month and two last digits of year) and
temperature (while the device is equipped with optional temperature sensor). The time is
presented in 24-hours mode only, and internal battery preserves proper time counting, even if
device is turned off from power supply. The
SWZ-W610
is designed to operate in closed
rooms where relative humidity is lower than 90% and no condensation occurs. The brightness
of display can be adjusted in 8 steps. It is possible to connect external DCF-77 signal receiver
to the clock. (DCF-77 signal receiver is not a part of the
SWZ-W610
set. It is an additional
equipment.)
The device has 4 buttons used for main pre-sets programming. To get higher protection
level, the keyboard is mounted under transparent cover. It is possible to set the device using
Infra Red controller, or RS 485 serial interface with MODBUS RTU protocol.
The remote controller keyboard is equivalent to the device keyboard (Remote controller is
not a part of the
SWZ-W610
set. It is an additional equipment.).
3.
TECHNICAL DATA
Power supply voltage
(depending on version)
External fuse (required)
Power consumption
85...
230
...260V AC/DC; 50 ÷ 60 Hz
19...
24
...50V DC; 16...
24
...35V AC
T - type,
max. 2 A
max. 11 VA @ 85 ÷ 260V AC/DC
max. 11 VA @ 16V ÷ 35V AC
max. 10 W @ 19V ÷ 50V DC
Outputs
supply 24V:
supply 5V:
24V DC ± 5% / max. 100 mA;
5V DC ± 5% / max. 50 mA;
4
!
!
