User manual for digital clock SWZ-W610
in EEPROM) press
[ENTER]
button shortly after
”SEt?”
is displayed. To cancel the changes
press
[ESC]
button shortly after
”SEt?”
is displayed. After that device returns to the menu.
7.2.2.
Numeric parameters (slide change mode)
In “slide change” mode („
Edit
”=”
Slid
”), buttons
[^]
and
[v]
has different functions.
To increase edited value press (or press and hold)
[^]
button only, the increasing
became quickest as long as button
[^]
is pressed.
To slow down the increasing, button
[v]
can
be used. If
[v]
is pressed shortly (and button
[^]
is still pressed), increasing slow down for
a moment only, if
[v]
is pressed and held while button
[^]
is still pressed the increasing slow
down and will be kept on lower speed.
To decrease edited value press (or press and hold )
[v]
button only. The decreasing
became quickest as long as button
[v]
is pressed.
To slow down the decreasing, button
[^]
can be used. If
[^]
is pressed shortly (and button
[v]
is still pressed), decreasing slow down for
a moment only, if
[^]
is pressed and held while button
[v]
is still pressed the decreasing slow
down and will be kept on lower speed.
Press
[ENTER]
at least 2 seconds to accept the changes, after that question
”SEt?”
is
displayed, and user must to confirm (or cancel) the changes. To conform changes (and story it
in EEPROM) press
[ENTER]
button shortly after
”SEt?”
is displayed. To cancel the changes
press
[ESC]
button shortly after
”SEt?”
is displayed. After that device returns to the menu.
7.2.3.
Switch parameters (“LIST” type)
Switch parameters can be described as a sets of values (a lists) out of which only one of
the options available on the list can be selected for the given parameter. Options of switching
parameter are selected using
[^]
,
[v]
keys.
Short pressing of
[ENTER]
causes in displaying of the acknowledge question (
”SEt?”
).
If
key
[ENTER]
is pressed again, the changes are accepted, stored in EEPROM end the edition
process finished. Pressing the key
[ESC]
after
”SEt?”
causes in cancelling of made changes
and returning to menu.
Functions of buttons when editing numeric and switching parameters:
While editing numeric parameter:
•
change of current (flashing) digit
•
slide change of value (acceleration, deceleration, direction change)
While editing switch parameter - selection of switch parameter.
If numerical parameter is being edited, a short press of
[ENTER]
button
change edited position. A long press of
[ENTER]
button (at lest 2 sec.)
causes of display a
”SEt?”
ask, which allow user to make sure if change of
the parameter value is correct. If switch parameter is being edited, a short
press of
[ENTER]
button causes of display a
”SEt?”
ask. When
[ENTER]
button is pressed again (while
”SEt?”
is displayed) the new value of the
parameter is stored in EEPROM memory.
Pressing this button operator can cancel the changes done up to now (if they
were not approved by
[ENTER]
button after the
”SEt?”
ask) and come back
to menu
15
MENU
ESC
ENTER