User manual for digital clock SWZ-W610
7.
DEVICE PROGRAMMING
The device menu allow user to set all parameters connected to operation of the display,
control modes, communication via RS-485 and access settings. The meaning of the particular
parameters is described in paragraph
MENU DESCRIPTION
.
7.1.
PROGRAMMING MENU
To enter main menu (being in the displaying mode) operator must to press and hold at
least 2 sec.
[ESC/MENU]
button.
If the user password is defined (see parameter
“Scod“
), operator have to enter correct one
before proceeding to menu options . Entering of the passwords is similar to the edition of
numeric parameters
(see:
PARAMETERS EDITION
)
,
however presently editing digit is showed
only on the display, other digits are replaced by “-” sign.
After entering of last digit of the password first menu position will be displayed (if the password
is correct) or warning ”
Err
” in other case.
Functions of the buttons while sub-menu and parameters choice:
Selection of sub-menu or parameter for editing. Name of selected item (sub-
menu or parameter) is displayed.
Operation of
[ENTER]
button depend on present menu position:
•
if the name of some sub-menu is displayed - enter this sub-menu; name
of the first parameter (or next level sub-menu) is displayed,
•
if the name of some parameter is displayed - enter the edition of this
parameter; present value of the parameter is displayed,
[ESC/MENU]
button allow user to exit present menu level and goes to upper
level menu (or displaying mode).
After about 1 min. since last use of the buttons, device exits the menu mode and
returns to the displaying mode (only if no parameters are in editing mode).
7.2.
PARAMETERS EDITION
To start edition of any parameter user should select name of desired one using
[^] [v]
buttons and then press
[ENTER]
.
7.2.1.
Numeric parameters (digit change mode)
Numerical parameters are displayed as decimal numbers. The mode of its new value entering
depends on chosen edit method ( see parameter „
Edit
”).
In mode “by digit” („
Edit
”=”
dig
”) pressing one of the keys
[^]
or
[v]
causes change of
current position (flashing digit) or the sign (+/-). Short pressing of the
[ENTER]
button causes
change of the position (digit).
Press
[ENTER]
at least 2 seconds to accept the changes, after that question
”SEt?”
is
displayed, and user must to confirm (or cancel) the changes. To conform changes (and story it
14
ENTER
MENU
ESC
i