User manual for digital clock SWZ-W610
Symbols and functions of push-buttons:
Symbol used in the manual:
[ESC/MENU]
Functions:
•
Enter to main menu ( press and hold by at least 2 sec.)
•
Exit the current level and Enter to previous menu (or displaying mode)
•
Cancel the changes made in parameter being edited
Symbol used in the manual:
[ENTER]
Functions
:
•
Start to edit the parameter
•
Enter to the sub-menu,
•
Confirmation of changes made in parameter being edited
•
Changing of display mode, in sequence: present time, present date and
temperature (optional)
Symbol used in the manual:
[^] [v]
Functions
:
• Change of the present menu,
• Modification of the parameter value,
• Change of the display mode.
6.
PRINCIPLE OF OPERATION
After turning the power supply on, device ID and software version are showed on the
display, next the digital indicator goes to the display mode.
6.1.
DISPLAYING MODE
In normal mode current time is presented in format „
hours:minutes
seconds
” or current
date in format „
day.month.
year
”. Additionally, if digital temperature sensor module is
connected to {
THERM
} input, the device can display current temperature near the sensor. The
display can show only one of these parameters, or can change them in sequence, with periods
selected by user.
The displaying time of particular readings are defined by parameters
”dL c”
(time displaying
period),
”dL d”
(date displaying period) and
”dL t”
(temperature displaying period).
•
To omit the date in displaying sequence, parameter
”dAtE”
of
”Func”
menu
must be switched to
”oFF”
. If
”dAtE”
=
”oFF”
, then parameter
”dL d”
is
unavailable.
•
To add displaying of temperature in sequence, thermometer function must be
on (parameter
”thEr”
of
”Func”
menu set to
”on”)
. If this function is off (
”thEr”
=
”oFF”
) parameter
”dL t”
is unavailable.
Pressing
”ENTER”
button, user can switch display to show selected reading. Successive
pressing of this button causes in displaying of next reading in the cycle.
Setting any of
”dL c”
,
”dL d”
or
”dL t”
display period to „00” (zero) causes in stopping of
the sequence corresponding reading. If user press
”ENTER”
button
after stopping the
sequence, and display period of current reading is different than 0, the sequence run until next
reading with display period equal „00”.
11
MENU
ESC
ENTER
i
