Simex SRP-N1186, User Manual

Page: 55 / 64

User manual - METER SRP-N1186
Register Write Range Register description
46h Yes see descr.
“ SEt2 ” parameter in “ rEL1 ” menu, no decimal point included –
lower word
47h Yes see descr.
“ SEtP ” parameter in “ rEL2 ” menu, no decimal point included –
higher word
48h Yes see descr.
“ SEtP ” parameter in “ rEL2 ” menu, no decimal point included – lower
word
49h Yes see descr.
“ HySt ” parameter in “ rEL2 ” menu, no decimal point included –
higher word
4Ah Yes see descr.
“ HySt ” parameter in “ rEL2 ” menu, no decimal point included –
lower word
4Bh Yes 0 ÷ 5
“
modE
” parameter in “
rEL2
” menu:
0
- “
noAC
” mode;
1
- “
on
” mode;
2
- “
oFF
” mode;
3
- “
in
” mode;
4
- “
out
” mode;
5
- “
modb
” mode
4Ch Yes 0 ÷ 999
“t on” parameter in “rEL2” menu, expressed in tenth of seconds or
tenth of minutes depend on “unit” parameter - register no. 4Eh)
4Dh Yes 0 ÷ 999
“toFF” parameter in “rEL2” menu, expressed in tenth of seconds
or tenth of minutes depend on “unit” parameter - register no. 4Eh)
4Eh Yes 0 ÷ 1
“unit” parameter in “rEL2” menu:
0 - seconds; 1 - minutes
4Fh Yes 0 ÷ 2 “AL” parameter in “rEL2” menu: 0 - no changes; 1 - on; 2 - off
50h Yes see descr.
“ SEt2 ” parameter in “ rEL2 ” menu, no decimal point included –
higher word
51h Yes see descr.
“ SEt2 ” parameter in “ rEL2 ” menu, no decimal point included –
lower word
68h Yes 0 ÷ 1
“ modE ” parameter in “ HOLd ” menu (type of detected changes):
0 - peaks; 1 - drops
69h Yes see descr.
“ PEA ” parameter in “ HOLd ” menu (minimum detectable change, no
decimal point included) – higher word
6Ah Yes see descr.
“ PEA ” parameter in “ HOLd ” menu (minimum detectable change, no
decimal point included) – lower word
6Bh Yes 0 ÷ 199
“ timE ” parameter in “ HOLd ” menu, maximum peaks' (or drops')
display time expressed in seconds
6Ch Yes 0 ÷ 1
“ HdiS ” parameter in “ HOLd ” menu:
0 - “ rEAL ” mode ; 1 - “ HOLd ” mode
6Dh Yes 0 ÷ 1
“ H r1 ” parameter in “ HOLd ” menu :
0 - “ rEAL ” mode ; 1 - “ HOLd ” mode
6Eh Yes 0 ÷ 1
“ H r2 ” parameter in “ HOLd ” menu:
0 - “ rEAL ” mode ; 1 - “ HOLd ” mode
71h Yes 0 ÷ 1
“ HOUt ” parameter in “ HOLd ” menu:
0 - “ rEAL ” mode ; 1 - “ HOLd ” mode
77h 5 Yes see descr.
The value of „
X
” coordinate of point
no. 1
of the user defined
characteristic, expressed in 0.1% – higher word
55