Simex SLC-94, User Manual

Page: 19 / 36

User manual for - TIMER SLC-94
7.2. MENU DESCRIPTION
“- - - -” Password checking. If any password different from „ 0000 ” is set, than every
enter to main menu follows the entering of password. If entered password is
correct first menu position will be displayed else warning ”
Error
”, and unit returns
to measurement mode.
Due to problem with direct displaying of “ m ” letter, it is exchanged with special sign
“ “. Independently in user manual letter „ m ” is used to make it more readable
(example: “modE” ).
7.2.1. “ rELAy1 ” ÷ “ rELAy2 ” menu
This menu allows to configure the operation mode of relays and LEDs marked „ R ” (e.g.
„ R1 ”).If there are few relay outputs available, then every output has its own configuration
menu (e.g. menu „ rEL2 ” for relay (LED) „ R2 ”). Principle of the relays operation is described in
paragraph CONTROL OF THE RELAY OUTPUTS .
“ SEtP 1 ”÷ “ SEtP 2 ” - setting of relay threshold . The threshold value is edited by all
parameters below together:
“ Hr ” - hours, range 0 ÷ 99 999,
“ min ” - minutes, range 0 ÷ 999 999,
“ SEc ”
- seconds, range 0 ÷ 999 999,
“ mSEc ” - milliseconds, range 0 ÷ 999 999.
the sum of all of these parameters decides what is exact threshold value. Detailed description
of threshold value setting method is described in paragraph 6.2
If
“Src”
parameter equals
“total”
then “
mSEc
” parameter in relay threshold edition menu
(“ SEtP1 ” i “ SetP2 ”) is non active and equals zero.
“modE 1” ÷ “modE 2” - operation mode. Defines active state of the relay, that means
state after counter reached threshold value. Following values are available:
“noACt” - not active (relay permanently opened)
“on”
- relay closes when counter reaches
threshold value
“oFF” - relay opens when counter reaches threshold value
“Src 1”
,
“Src 2”
- control source, this parameter allows to select what counter (main timer
or totalizer) has to control particular relay, available values:
„curr” - main timer controls relay
„total” - totalizer controls relay
Closed contactors of an relay are indicated by lighted Led.
19
i
i
i