User manual for - TIMER SLC-94
If the user password is defined (see parameter
“SEtcod“
), operator have to enter correct
one before proceeding to menu options. Entering of the passwords is similar to the edition of
numeric parameters
(see:
PARAMETERS EDITION
)
,
however presently editing digit is showed
only on the display, other digits are replaced by “-” sign.
After entering of last digit of the password first menu position will be displayed (if the password
is correct) or warning ”
Error
” in other case.
After entering menu mode, buttons change its meaning (see table below), independent
of “
PuSH
” parameter settings (it means, even if they are used to control time measurement).
After exiting menu buttons can be used to control measurement again.
Functions of the buttons while sub-menu and parameters choice:
Selection of sub-menu or parameter for editing. Name of selected item (sub-
menu or parameter) is displayed.
Operation of
[ENTER]
button depend on present menu position:
•
if the name of some sub-menu is displayed - enter this sub-menu; name
of the first parameter (or next level sub-menu) is displayed,
•
if the name of some parameter is displayed - enter the edition of this
parameter; present value of the parameter is displayed,
[ESC/MENU]
button allow user to exit present menu level and goes to upper
level menu (or measurement mode).
After about 1 min. since last use of the buttons, device exits the menu mode and
returns to the measurement mode (only if no parameters are in editing mode).
7.1.1.
parameters edition
To start edition of any parameter user should select name of desired one using
[^] [v]
buttons and then press
[ENTER]
.
7.1.2.
Numeric parameters (digit change mode)
Numerical parameters are displayed as decimal numbers. The mode of its new value
entering depends on chosen edit method ( see parameter „
Edit
”).
In mode “by digit” („
Edit
”=”
dig
”) pressing one of the keys
[^]
or
[v]
causes change of
current position (flashing digit) or the sign (+/-). Short pressing of the
[ENTER]
button causes
change of the position (digit).
Press
[ENTER]
at least 2 seconds to accept the changes, after that question
”SEt?”
is
displayed, and user must to confirm (or cancel) the changes. To conform changes (and story it
in EEPROM) press [ENTER] button shortly after
”SEt?”
is displayed. To cancel the changes
press [ESC] button shortly after ”SEt?” is displayed. After that device returns to the menu.
17
MENU
ESC
ENTER
i
