Operation • Service • Repair Parts
5
For parts or assistance, call Simer Customer Service at 800-468-7867
Operation
NOTICE Do not allow pump to run in a dry
sump. It will void the warranty and may damage
the pump.
An automatic overload protector in the motor
will protect motor from burning out due to
overheating/overloading. When motor cools
down, overload protector will automatically
reset and start motor.
If overload trips frequently, check for cause. It
could be a stuck impeller, wrong/low voltage, or
electrical failure in motor. If an electrical failure
in the motor is suspected, have it serviced by a
competent repairman.
Pump is permanently lubricated. No oiling or
greasing is required.
Service
Hazardous voltage. Can shock, burn,
or cause death. Before removing pump from
basin for service, always disconnect electrical
power to pump and control switch.
Risk of electrical shock. Can burn or
kill. Do not lift pump by power cord. See Cord
Lift Warning.
Submerge pump in a disinfectant solution (dilute
chlorine solution) for at least one hour before
servicing pump.
The pump motor contains a special lubricating
oil which should be kept clean and free of water
at all times.
Check operation by filling sump with water
and observing pump operation through one
complete cycle.
Risk of flooding. May cause personal
injury or property damage. Failure to make this
operational check may lead to flooding and
premature failure.
NOTICE This unit is not designed for
applications involving salt water or brine! Use
with salt water or brine will void warranty.
Repair Parts
Description
Part Number
Power Cord: 10’, 115 V
146230101
Tethered Float Switch
FP18-15BD
Impeller
PS5-273P
Hazardous voltage. Disconnect pump
from electrical power before replacing cord or
switch. Do not remove impeller housing (volute).
There are no consumer serviceable parts inside
the pump.