–prepare the head, proceeding as
above, and bring it up to the inter-
mediate section. Add only one sec-
tion at a time;
– assemble the sections, using the tools
provided consisting of a pair of stay-
bolts for assembly with the correspon-
ding accessories (code 6050900 - fig.
4), exerting pressure simultaneously
on the top hub and on the bottom
hub. If, during this operation, the sec-
tions were to slot together in such a
way as not to be even and parallel,
slide a chisel in the tighter side and, by
applying a little force, bring the two
pieces together so that they are
parallel. The sections can be conside-
red properly joined together when
their outer edges come into contact;
–insert the bead of putty in the groo-
ve of the section that has just been
assembled, and then proceed to joi-
ning up the other sections until the
body is completed.
NOTE: Before proceeding to connect
the system, test the boiler block with
a water pressure of 7.5 bar.
2.6
ASSEMBLY OF SMOKE
CHAMBER
For ease of shipping, the smoke cham-
ber comes supplied in four pieces, which
are to be joined together using the
screws provided (fig. 5). The smoke
chamber is assembled by fastening the
right-hand side panel (2) to the top panel
(1), using the nine hexagonal-head self-
tapping screws 12E x 1/2” supplied in
the plastic bag. Repeat the same opera-
tion for the left-hand side panel (3).
Finally, fasten the cleaning panel (4),
using the screws provided. Once assem-
bly is complete, place the smoke cham-
ber over the cast-iron body. Fasten the
smoke chamber to the cast-iron body,
using the four plates and the four
screws TE M8 x 30 supplied (fig. 5/a).
2.7
ASSEMBLY OF WATER
DISTRIBUTOR
The water distributor, located on the
return manifold, is positioned on the
right-hand side of the boiler.
Should it be necessary to move it to
the left-hand side, check that the two
rows of holes made on it are facing one
upwards, and the other towards the
front of the boiler (fig. 6).
The water distributor is not installed in
models
“RS 6-7”
.
52
KEY
1 Pin
2 Flange ø 35/87
3 Biconical nipples
4 Staybolt L. 900 +
staybolt L. 780
5 Flange ø 50/87
6 Stub
7 Thrust bearing
8 Nut
9 Tightening wrench
Fig. 4
KEY
1 Top panel
2 R.H. side panel
3 L.H. side panel
4 Cleaning panel
Fig. 5
KEY
1 Screw TE M8 x 30
2 Plate
3 Washer ø 8,4
4 Nut M8
Fig. 5/a
Summary of Contents for RS 10
Page 1: ...RS IT ES GB PT...
