60
2.5.2.3 HEATER FIRING UP/SHUTTING DOWN
Firing (or shutting-down) the controlled heater is accomplished by pressing the ON/OFF key (key #5) from within the START screen; the
panel will beep and the displayed status will be updated.
2.5.3 QUICK ACCESS FUNCTIONS
By pressing one of the 4 side buttons from within the START screen changes the display to the SELECTION screen (See Fig. 50), where
the “quick access functions” may be set.
m o d e : M A N U
M e n u
F i r e : 4
Fig. 50
SELECTION screen
As shown in the picture, the main function descriptions appear close to the 4 buttons.
• The advanced functions may be selected by pressing the Menu key (See §
2.5.4).
• The Fire key cycles through the power values.
• The display reverts back to the START screen by pressing the On/Off key.
2.5.3.1 POWER FINE SETTING
The Fire key (key #2) cycles the requested power values sequence. By holding the key pressed for 2s, the selection screen will appear
(See Fig. 51); from within this screen the value may be changed by1 level steps, within an interval ranging from 1 to the maximum value
which depends on the controlled heater model (3 ÷ 9).
e s c
O k
-
F i r e
+
Fig. 51
SET_POT screen
The value on the top line flashes to let the user know that it may now be changed. By pressing the b (key #4) and - (key #2), the
value may be increased/decreased, while the key Ok (key #3) confirms the new value and the display reverts to the SELECTION screen
(See Fig. 50).
By pressing the esc key (key #1), the display returns to the SELECTION screen without confirming the new value. The display returns to
the START screen without confirming the new value by pressing the On/Off key (key #5).
2.5.3.2 ECO MODE
(See §
2.5.4.4 )
In Manual Mode, it’s possible to enable this function only if the Thermostat option is active .
In the Automatic Mode , however, it’s always possible to enable this function .
ECO function remains active until it is set off from within the setting menu (See §
2.5.4.4).
Summary of Contents for 8058540
Page 71: ......
