10
ht5000HB - pro5dl
5 START-UP AND ShUTDOwN
ATTENTiON: Connect the units to a mains electrical supply
with rated voltage of between 110-240 VAC, 50/60 hz and
equipped with a protective earth connection (fig. 8).
I
0
Power Switch:
Position I: On
Position 0: Off
Fused
Power Socket
Power Plug
Fig. 8
In position I, the projector runs a number of initialization steps
(red and blue lights on), and then it goes into standby status
(red light on) (Fig. 9).
I
0
START-UP fROM STANDBY STATUS
From the remote control: press one of the keys
1...9 or 0.
From the keypad: press the on/off key
I
0
0
When starting from standby, the lamp comes on. After a short
warm-up, the image appears (blue light on). The projected
image comes from the input selected at the time of the last
shutdown (Fig. 10).
If too little time has elapsed since the last shutdown, the lamp
may not light if it is too hot.
In this case, you should let the lamp cool off for a few min-
utes.
ShUTDOwN AND RETURN TO STANDBY STATUS
From the remote control: press the key .
From the keypad: press the ON/OFF key
Upon shutdown, the projector reverts to standby status, and
memorizes the input selected at the time of shutdown.
The fans continue to run until the lamp is cool (red and blue
lights on). Then they shut off automatically. Do not turn off the
projector with the network switch until the fans stop running.
Fig. 9
Fig.10
