12 GB
6. Use both hands to press firmly on the
edges of the lid
12
. They must audibly
click into place.
7. Press the button
4
. The LED lights up.
The film bag is first vacuum-packed and
then sealed.
The LED goes out when the process is
complete.
NOTE:
If the LED
4
does not go out and the
noise of the vacuum pump does not stop, de-
spite the fact that no further air is being
sucked out of the film bag, cancel the pro-
cess. Check that the film bag is in the correct
position in the device, and check for leaks.
8. Simultaneously, press buttons
9
in order
to release the lock of the lid
12
.
9. Open the lid
12
and remove the bag.
10. Check the welding seam. It should be a
smooth creaseless seam.
9. Cleaning and storage
DANGER! Risk of injury
through burning/scalding!
~
Allow the device to cool down com-
pletely before you clean it or put it
away.
~
The welding wire
17
becomes very hot
during operation. Do not touch the hot
welding wire
17
.
DANGER! Risk of electric
shock!
~
Prior to cleaning, disconnect the mains
plug
6
of the device.
DANGER! Risk of electric
shock due to moisture!
~
The device and the power cable with
mains plug
6
must not be immersed in
water or other liquids.
WARNING! Risk of material dam-
age!
~
Do not use any sharp or abrasive clean-
ing agents.
9.1 Cleaning
In order to ensure the proper function and
the full capacity of your device, clean it reg-
ularly.
•
Wipe down the housing of the device
with a damp cloth.
•
Prior to the next use, the device must be
completely dry.
Collector
1. Grasp the centre or both outer ridges
with your fingers and carefully lift the
collector for liquids
18
out upwards.
2. Drain the liquid.
3. Rinse the collector
18
under warm dish-
water or place it in the dishwasher.
Make sure it is dry before inserting it.
4. Insert the collector
18
into the device
from above.
Sealing ring
1. Grasp the sealing ring
16
with two fin-
gers and lift it off upwards.
2. Rinse the sealing ring
16
under warm
dishwater. Make sure it is dry before in-
serting it.
3. Replace the sealing ring
16
in the re-
spective form inside the device. Ensure
that it lies in smooth contact and is not
wavy.
NOTE:
the sealing ring
16
is a wearing
part. Due to the high contact pressure, it will
__321553_Vakuumierer_B7.book Seite 12 Donnerstag, 4. Juli 2019 12:04 12
