11
GB
3. Place the bag in the device. For this pur-
pose, the end of the film bag must be
positioned just before the rear reference
ridges
13
and the side reference ridg-
es
15
.
4. Ensure again that there are no creases
in the film bag - especially in the area
above the welding wire
17
.
5. Close the lid
12
.
6. Use both hands to press firmly on the
edges of the lid
12
. They must audibly
click into place.
7. Press the button
3
. The LED lights
up. The film bag is being sealed.
After approx. 5 - 7 seconds, the LED
goes out and the sealing process is com-
pleted.
NOTE:
If you have activated the
Wet
1
function, the sealing process takes a few sec-
onds longer.
8. Simultaneously, press buttons
9
in order
to release the lock of the lid
12
.
9. Open the lid
12
and remove the bag.
10. Check the welding seam. It should be a
smooth creaseless seam.
8.7 Vacuum-packing and
sealing bags (without
valves)
DANGER! Risk of electric
shock due to moisture!
~
For vacuum-packing, no liquids must be
inside the bag.
~
Ensure that no liquid is sucked in during
the extraction of air. If this nevertheless
occurs, immediately interrupt the pro-
cess by pressing the active function but-
ton
4
again.
NOTE:
When vacuum-packing film bags,
there must not be any vacuum tube
19
plugged into the connection
8
.
1. Smooth the bag where it is to be
sealed.
2. Open the lid
12
.
3. Place the bag in the device. For this pur-
pose, the end of the film bag must be
positioned just before the rear reference
ridges
13
and the side reference ridg-
es
15
.
4. Ensure again that there are no creases
in the film bag - especially in the area
above the welding wire
17
.
5. Close the lid
12
.
__321553_Vakuumierer_B7.book Seite 11 Donnerstag, 4. Juli 2019 12:04 12
