57
GB
MT
SFS 110 A1
NOTE
►
The bag opening must lie fl at on the welding wire
4
. Otherwise the weld-
ing does not work properly.
4) Close the appliance lid
1
. The press seal
0
presses the bag onto the welding
wire
4
, to create a smooth seam. Ensure that both corners of the appliance
lid
1
click closed. If necessary, press them down once again on the markings
and
so that the appliance lid
1
clicks into place and locks shut.
5) Press the button
w
. The red control lamp
q
lights up. As soon as the
sealing process is fi nished, the red control lamp
q
goes off .
NOTE
►
You can halt the sealing process at any time by pressing the
button
e
.
The red control lamp
q
goes out.
CAUTION – PROPERTY DAMAGE!
If the red control lamp
q
does not go out after a maximum of
10 seconds, there is a fault with the appliance.
►
Remove the plug from the mains power socket immediately. Do not attempt
to repair the appliance yourself. Contact the Customer Service department.
6) Open the appliance lid
1
and remove the bag. This is now welded at one end.
NOTE
►
Ensure that the weld seam is properly closed. A correct weld seam should
be a smooth, straight stripe without any creases.
7) Fill the bag. You must leave at least 6 cm of the bag free up to the edge to
be welded.
CAUTION – PROPERTY DAMAGE!
►
Fill the bag so that no food scraps or liquids can leak out during welding
and get into the appliance.
8) If you do not want to vacuum the bag, you can now weld the other, open side.
IB_104351_SFS110A1_LB5.indb 57
03.12.14 16:11
