8
SAR 28 A1
GB
IE
1 3 5 7
2 4 6 8
ISO B
(speaker connec-
tion assignment)
Assignment
1
Rear right +
2
Rear right -
3
Front right +
4
Front right -
5
Front left +
6
Front left -
7
Rear left +
8
Rear left -
To connect the device to two speakers, only use the cables for the front speakers.
NOTE
►
Ensure that a steady plus connection is applied to the station memory of
connector 4 in ISO Block A.
►
In some vehicle models, the default assignment of connectors [4] and [7] in
ISO Block A are interchanged at the factory. If this is the case, the station
memory can be lost. To remedy this, connectors 7 (ignition positive) and 4
(permanent plus) in ISO Block A must be swapped. To do this, connect the
supplied adapter cable
33
between the ISO Block A on the car stereo and
the car wiring harness.
Use the adapter cable to connect the red wire of the ISO plug to the yellow
wire in the ISO socket, and the yellow wire of the ISO plug to the red wire
in the ISO socket (see also back fold-out page).
CAUTION
►
When using the adapter cable for the ISO Block A, both connections
(red and yellow wires) must be connected together. Otherwise there is a
risk of a short circuit!
Antenna control voltage connection
CAUTION
►
Never load the antenna control voltage with the motor power cable or
other power consumers.
NOTE
►
If you want to use the antenna control system and the supplied adapter
cable
33
you must remove the shrink tubing on the antenna control voltage
cable (blue) and push the contact into the appropriate duct of the ISO
Block A socket. For more information on wiring, refer to the instruction
manual of your vehicle.
IB_106770_SAR28A1_LB3.indb 8
14.11.14 14:31
Summary of Contents for 106770
