Fox-in-a-Box® Thermal Printer Installation Guide
Loading Thermal Ribbons
4.
Slide the empty card core onto the ribbon
holder as shown:
5.
Place the empty card core on the ribbon holder
onto the front ribbon mountings and peal off the top
strip from the double-sided tape :
6.
Now take the end of the clear lead-in material and feed underneath to the rear of the cardboard core and stick to
the core using the double-sided tape. Then wind the clear material onto the core
anti-clockwise
as shown in the
images below:
VERY IMPORTANT!
Please note the front roll will
rotate the same way as the
rear roll – ie: anti-clockwise.
When fixing and winding the
lead-in on the front roll, you
need to wind it anti-
clockwise.
Do not under
any circumstances
attempt to rotate the
ribbon holders when the
printer head is locked
down as this may cause
damage to the winding
mechanism
.
7.
Close the ribbon carriage by pushing the head close knob down firmly, you should hear a 'click':
Your printer is now ready to load labels.
www.silverfox.co.uk
R4.0
Page 5 of 35
Copyright © 2015 Silver Fox Limited
