Silex technology DS-700AC, User Manual

Page: 30 / 200

22
DS-700AC User's Manual
(4) Push Switch
Resets DS-700AC to the factory default settings. For details, refer to
8-5-2. Resetting to Factory Defaults
.
Also, this switch can be used to configure the wireless settings. For
details, refer to
5-2. Configuration via WPS
.
(5) USB3.0 Port Connect a USB3.0 device. (USB3.0 Super-Speed)
(6) USB2.0 Port Connect a USB2.0 device. (USB2.0 Hi-Speed)
(7) LINK LED
ON (Green)
Indicates a network port status.
1000BASE-T:ON
ON (Orange) Indicates a network port status.
10BASE-T:ON / 100BASE-TX:ON
(8) POWER LED ON (Yellow) Lights up when DS-700AC is powered on.
(9) Network Port
Connect a network cable.
10BASE-T / 100BASE-TX / 1000BASE-T (Auto-sensing)
(10) Power Connector Connect an AC adaptor.
-
If an overcurrent is detected on a USB port, power supply to the USB port is automatically cut off via an
overcurrent protection feature.
-
If you are using USB devices that run on USB Bus power, it is recommended to avoid using two or more devices
at once, so that the total power used does not exceed the maximum power capability of DS-700AC.
TIP
<FRONT>
(7)
(4)
(5)
(6)
(8)
(9)
(10)