COPYRIGHT SERENYA
COD. 2001
SERENYA
by Silentron
– made in Italy
4.8.2) INTRUSION AND 24 HOURS ALARM GROUPS
– KEYPADS AND BIDIRECTIONAL SIRENS TAMPERS
REMOTE CONTROL
CONFIRM
ALARM GROUP A
CONFIRM
ALARM GROUP A
OUTDOOR ALARM N
Confirm (
) if we don’t want to
configure the partition as Outdoor
alarm. Press
to change N (no) to Y
(yes) = outdoor alarm
SENSOR A01
CONFIRM
SENSOR A01
DELAY N AND N
Press
in case of Entry delay and AND function not necessary
Press 1
for DELAY and enter the entry time in seconds
Press 2 for AND : we’ve to program 2 detectors
SENSOR A01
INSERT BATTERY
b
i
p
SENSOR A01
DELAY 0 SEC
(Y) (Y)
LABEL A01
CUISINE (exemple)
Write an 8 digits name. Clear to well
identify the detector
VOCAL LABEL
TO RECORD
Talk close to the microphone.
Press
for all the recording
time. Verify the remaining
time (total 240 seconds)
RECORDING
228 . 227 . 226 . 225 . . .
After recording automatic listening.
Press ESC to exit,
to listen again
or CANC to delete and restart
E
S
C
ALARM GROUP A
CONFIRM
ALARM GROUP A
OUTDOOR ALARM N
SENSOR A02
CONFIRM
Continue as above with the detectors
of the partition A. To change
partition use
at the beginning of the specific menu
TO MODIFY AND DELETE PROGRAMMED DEVICES:
Entering into the EXTRAS menu and confirming a partition the control panel always shows the first free position.
Selecting a previous position (↓↑) the already programmed devices will appear. Confirm the one to be modified and procede, or delete pressing
CANC and re-program it.
4.9) SETTINGS:
in this section we can program certain particular functions of the control panel. Scroll the different functions using buttons
4.9.1) ) DETECTOR EXCLUSION
EXCL. SENSORS
CONFIRM
A 01
KITCHEN
CONFIRM
Select the detector you want
to exclude pressing
Select (
) INCLUD or
EXCLUD and confirm
The excluded sensors will
not give any alarm.
E
S
C
4.9.2) RADIO COMMANDS:
calling the control panel via telephone we can activate functions. Control panels have 16 possibles radio
commands to locally activate receivers RX,
whom on their turn can activate some functions as the lighting activation and to command home
automation devices in the local area. To be commanded by the control panel these receivers must memorize at least one of the RADIO
COMMANDS mentioned here following.
Attention!
When we press
to program the radio switch, it has to be ready for programming (look the specific instructions of the device).
RADIO OUTPUT
CONFIRM
RADIO OUTPUT 1
CONFIRM
RADIO OUTPUT 1
ON – OFF
Confirm the command as ON-OFF
or change it as IMPULSIVE (
)
Set the receiver and press
to
program it
ES
C
RADIO OUTPUT 1
CONFIRM
RADIO OUTPUT 2
CONFIRM
Continue in the same way up to 16 available radio commands.
4.9.3) MAIN POWER FAILURE:
follow the vocal instructions for the SMS
– look also 2.2.2
Summary of Contents for SERENYA 2000
Page 17: ...COPYRIGHT SERENYA COD 2001 SERENYA by Silentron made in Italy ...
Page 18: ...COPYRIGHT SERENYA COD 2001 SERENYA by Silentron made in Italy ...
Page 19: ...COPYRIGHT SERENYA COD 2001 SERENYA by Silentron made in Italy NOTE ...
Page 20: ...COPYRIGHT SERENYA COD 2001 SERENYA by Silentron made in Italy ...
