COPYRIGHT SERENYA
COD. 2001
SERENYA
by Silentron
– made in Italy
EXIT TIME
CONFIRM
EXIT TIME
T: 60 SECONDS
Change the factory time if
necessary by entering
a new time
4.9.12) AUTOMATIC SUMMER TIME
: this function is normally enabled but must be disabled in countries where it does not apply.
AUT. SUMMER H
CONFIRM
AUT. SUMMER H Y
CONFIRM
Choose N (no)
to set the unit without
automatic summer time
4.9.13) BACKLIGHTING
:
it is possible to have the display’ backlighting always active, but this reduce the autonomy in case of mains power
failure. The factory programming foresees the display switching-off after 60 seconds without any operation.
BACKLIGHTING
CONFIRM
BACKLIGHTING N
CONFIRM
Activate the function changing N
(no) in Y (yes) using the buttons
↑↓.
4.9.14) VOLUME
: the volume of the vocal information supplied by the control panel can be adjusted.
VOLUME
CONFIRM
VOLUME
V: █ █ █
█
Set VOLUME as desired
4.9.15) FORCED ARMING
: it is possible to obtain full or partial arming of the control unit at set times. Disarming must be manual.
FORCED ARMING
CONFIRM
FORCED ARMING N
A B C 00 : 00
Choose Y (yes) or N (no)
to set the function. Choose the
groups by pressing 1,2,3 and
enter the arming time
FORCED ARMING
Y
A B 20 : 30
4.9.16) FW VERSION:
display of the control unit version for any interventions.
FW VERSION
CONFIRM
FW VERSION
30155
4.9.17) SYSTEM RESET
: Confirmation of CANCEL? results in the erasing of all the programming performed and of the events memory. Be
careful before confirming this operation, which is irreversible.
SYSTEM RESET
CONFIRM
DELETE ?
CONFIRM
4.10) PROGRAMMING THE ALARM DEVICES/WIRELESS WARNINGS
(look specific instruction)
a) Receiver for command of electrical charges (Cod. 2041 - 42)
: these devices, after having been supplied, are automatically programmed
at the first radio signal sent by the control panel.
b) Bidirectional SIRENS Cod. 2032:
programming reception takes place as described above but it is first necessary to programme their
transmission to the control unit on any alarm zone group which will
be labelled “siren”.
c) Keypad:
for the arming/disarming the codes programmed in the control panel (look 4.8.2) can be used to associate one or more keypads to
the control panel and program the PANIC button (!). Procede as here following:
Give power supply to the keypad : all the LEDs are blinking
Within 60 seconds DISARM the control unit using its keys: the keypad LED indicators will turn off, confirming a successful connection. The
keypads already programmed can be re-programmed as follows..
Set the control panel on the PANIC partition and press the "
!
" key for 10 seconds , which has already been connected.
Summary of Contents for SERENYA 2000
Page 17: ...COPYRIGHT SERENYA COD 2001 SERENYA by Silentron made in Italy ...
Page 18: ...COPYRIGHT SERENYA COD 2001 SERENYA by Silentron made in Italy ...
Page 19: ...COPYRIGHT SERENYA COD 2001 SERENYA by Silentron made in Italy NOTE ...
Page 20: ...COPYRIGHT SERENYA COD 2001 SERENYA by Silentron made in Italy ...
