17
The blind moves up and down for approx. two minutes, showing
that the receiver is in programming mode.
3. Press the
OPEN
button as soon as the blind starts moving in
Open direction (within 1 second at the most). The status display
lights brie
fl
y.
The blind stops brie
fl
y, starts moving again, stops and then
moves in the Close direction.
4. Immediately (within maximum 1 second) after starting close
travel, press the
CLOSE
button. The status display lights brie
fl
y.
The blind stops. The transmitter channel is programmed.
Note
If the blind does not stop, it must be programmed again.
A bidirectional programming process in the hand-held
transmitter can be cancelled by pressing the
STOP
button for
6 seconds.
Programming additional transmitters
Note
If
several receivers
are connected to the
same feed line,
then all are simultaneously in programming mode for approx. 5
minutes after switching on the mains power.
If the
P
button on the transmitter is now pressed, all the
receivers start programming mode at the same time
( open/ close movements). Randomly different intervals between
open / close movements cause the receivers to become offset
against one another. The longer programming is delayed, the
greater the offset will be.
The short open/ close movements can be stopped by pressing
the
STOP
button brie
fl
y on a transmitter which has already
been programmed. The programming mode in the receiver is
interrupted.
Explanation of functions
