16
automatic shading system again. The shading setting must be set to
"Automatic ON".
The shading setting is set to “Automatic OFF” at the factory.
The activated automatic shading system is indicated in the function
bar of the display by an "
S
".
In unidirectional channels only a common setting is possible.
FUNCTION menu
Factory setting
Resets all settings except the receiver assignments linked to
channels to the factory settings. All the initial operation steps must
then be carried out.
During the initial commissioning, the following must be set using the
automatic menu guidance: "Language setting" -> "Town selection"
-> "Date/time".
Version
Indication of the current
fi
rmware version.
Programming the transmitter
Requirement
The receiver is installed.
Check whether the channel is deleted
or
in the correct mode according to the status display.
Stand in front of the blind to be programmed for the programming.
1. With electrical receivers which have already been installed,
switch the fuse off, and on again a few seconds later.
The receiver is now in programming mode for about 5 minutes.
2. Press the programming button
P
on the back of the device brie
fl
y
(approx. 1 second) until the status display lights for a short time.
Explanation of functions
