SILENT KNIGHT INTELLIKNIGHT 5820XL, Installation Manual

Page: 80 / 198

IntelliKnight 5820XL Installation Manual
5-12 151137
5.10 SLC Device Addressing
5.10.1 EEPROM Addressing
Select addresses for the following models through software as described here:
• Model SD505-AHS Heat Detector
• Model SD505-APS Photoelectric Smoke Detector
• Model SD505-AIS Ionization Smoke Sensor
You must use the Installer Code to perform this task. Here are the steps.
1. Connect a detector base temporarily to the programming terminals as shown in Figure
5-14. (You can use the same base for each detector.)
Figure 5-14 Temporary of Detector Base to Panel for Addressing
2. Enter the Installer code.
3. Select for Point Functions.
4. Select for Set SLC Dev Addr. (The panel will go into trouble at this point. You can use
the key to stop the PZT. The trouble will clear automatically when the panel rein-
itializes when you finish programming.)
5. Select “Yes” by pressing the up arrow, then press .
6. When the wait message clears, the following options display:
for Read Address. Use to read (or check) a single detector’s address.
for Write Address. Use to program a single detector’s address.
for Seq. Programming. Use to program more than one detector in sequential order.
7. If you are changing addresses, write the programmed address on the back of the device.
8. To exit press left arrow until fully exited.
2
3
SILENCE
ENTER
1
2
3