Instructions, use and maintenance manual
Pag. 34/48
TAURO 35-35PLUS-40-40PLUS
14.4.2.
How to tension belts and chains
-) Describe how to properly tension a drive belt is very complicated.
- measure the length of free section A in mm
- halfway on free section A and perpendicularly to the same, apply force F required to bend the belt (arrow) B (mm)
equal to A/100 (e.g. if A=500 mm, B=5,0 mm), use a millimetric reference to measure arrow B;
- the belt tension is correct if the force F applied for arrow B is between 12 and 18 N; measure the force using a
dynamometer or, even better, a tensiometer, which normally allows detecting arrow B; both are readily available on
the market.
For
further
information
contact
the
seller
or
consult
these
sites:
http://www.sitspa.it/it-
IT/Trasmissioni_a_cinghia_Poly-V.html
e
http://www.megadyneveneto.it/index.php/it/component/k2/item/223-
pluriband
.
-) Describe how to properly tension a drive chain is also very complicated.
The chain tension is correct when, by pushing it with your thumb halfway on the free section, it is not rigid
(otherwise it could break), but gives slightly and when released it goes back as it was; the chain meshes must be
free enough to rotate on the pins but not sag (otherwise they might come out of the gears).
If the user reasonably doubts his ability to to adjust the chain tension, do not use the machine and contact the
manufacturer as soon as possible for instructions.
http://www.ognibenechaintech.it/
.
