Instructions, use and maintenance manual
Pag. 31/48
TAURO 35-35PLUS-40-40PLUS
14.4.1.
Tensioning of belts and chains
To tension the spiral belt, remove the screws holding the upper casing together with the structure,
place the upper casing onto a flat surface and make sure that the sheath containing the wires is not
taut. Remove the rear casing also, Remove the rear casing also. As shown in the figure, loosen the
three nuts (1) and by leveraging the return shaft, tension the belt. Once tensioned, tighten the nuts (1),
put the casing back and test the machine.
To ensure the correct belt tension, see chap. 14.4.2.
ATTENTION: it is recommended to change the full series of belts to prevent the formation of dust.
INTERVAL
METHOD
s
F,M
FOR ANY MAINTENANCE AND CLEANING OPERATIONS, THE MACHINE MUST BE
OFF AND DISCONNECTED FROM THE ELECTRIC LINE.
Before performing any of the following operations, wear PPE such as: shoes with
reinforced tip and non-slip sole, gloves.
