Version 08/2008, Rev. 1.7 - sb
page 43 of 75
English translation
5.3.6 Program
The program is used to save or load certain recurrent settings of the centrifuge.
This saves time and prevents typing errors. 50 different programs can be saved
and called up. This is only possible at a standstill.
5.3.6.1 Saving the Current Settings
To save the current settings:
•
Turn the left rotary knob until “save” appears on the display (Fig. 5.21).
•
Select the option by pressing the right rotary knob. “Save” will now flash.
•
Turn the right rotary knob until the desired program number is displayed.
Empty storage location numbers flash.
•
Press the right rotary knob or the start key to confirm the input.
The settings are now saved under this program number (program number 8 in
the example).
5.3.6.2 Calling Up Stored Programs
If necessary, the saved programs can be called up:
•
Turn the left rotary knob until “run” appears on the display (Fig 5.22).
•
Select the option by pressing the right rotary cursor. “Run” will now flash.
•
Turn the right rotary knob until the desired program number is displayed.
•
Press the right rotary knob or the start key to confirm the input.
The saved program settings will be adopted.
Fig. 5.21: Saving programs;
here program number 8
Fig. 5.22:
Calling up stored programs;
here program number 8
