Copyright © Sigicom AB 2019
17
Figure 2-1 C12 with top lid open (SIM card and CompactFlash inserted
half-way in).
To pull out the CompactFlash, use a small flat screwdriver. Locate the
holes in the protection plate covering the electronics inside the C12.
Carefully insert the screwdriver in the holes and bend out the card bit by
bit, by alternating between the holes, until you can grip the card edge with
your fingertips.
Read about file types and the CompactFlash in section 3.3 File Types. All
configuration of the C12 is located in the directory ‘/config’ on the
CompactFlash.
Note! Do not remove the CompactFlash while the C12 is running.
Note! The C12 should not be used without a CompactFlash inserted. If the
CompactFlash is missing during startup, all LEDs will first be lit for
approx. 60 seconds. After that the
Check
LED (red) and
Reg
LED (green)
will flash simultaneously until the instrument is turned off.
