Installation manual
Инструкция
по
монтажу
CSF_HW_TUBE_R_R
PN 010817
/CSF/HW/BI/EU
OPERATING LIMITS
- Maximum temperature of flow: 70°C - Minimum temperature of flow: 4°C
- Maximum working pressure: 10bar
- Minimum room temperature: 4°
INSTALLATION
Important notice
- The unit installation work must be done by qualified personnel according to the local rules and this manual.
- Before installing, please contact with local authorized maintenance center, if unit is not installed by the
authorized center, the malfunction may not solve (unite can broke), due to discommodious contacts.
Basic requirements for installation position
Installation in the following place may cause malfunction. If it is unavoidable, please contact with service
center .
- Place where strong heat sources, vapors, flammable gas or volatile object are emitted.
- Place where a lot of salinities such ad coast exists.
- Place where the oil (machine oil) is contained in the air.
- Place whewre a sulfured gas such as the hot spring zones is generated. - Other place with special
circumstance.
Unit installation position selection
- The ait inlet and outlet vent should be far from the obstruction, make sure that the air can be blown through
the whole room.
- Select a position where the condensing water can be easily drained out.
- Select a location where children can no reach.
- Select the place where is strong enough to withstand the full weight and vibrations of the unit and will not
increase the noise.
- Be sure to leave enough space to allow access for routine maintenance; the height of the installed location
should be 2,5m or more from the floor.
070 / 090
HW 070 -090 HW 180
OPERATING LIMITS
- Maximum temperature of flow: 70°C
- Minimum temperature of flow: 4°C
- Maximum working pressure: 10bar
- Minimum room temperature: 4°
INSTALLATION
Important notice
- The unit installation work must be done by qualified personnel according to the local rules and this
manual.
- Before installing, please contact with local authorized maintenance center, if unit is not installed by the
authorized center, the malfunction may not solve (unite can broke), due to discommodious contacts.
Basic requirements for installation position
180
HW 070 -090 HW 180
OPERATING LIMITS
- Maximum temperature of flow: 70°C
- Minimum temperature of flow: 4°C
- Maximum working pressure: 10bar
- Minimum room temperature: 4°
INSTALLATION
Important notice
- The unit installation work must be done by qualified personnel according to the local rules and this
manual.
- Before installing, please contact with local authorized maintenance center, if unit is not installed by the
authorized center, the malfunction may not solve (unite can broke), due to discommodious contacts.
Basic requirements for installation position
4
