.
Cover the top surface of your building board with a large piece of "Celotex" or even foam insulation board, which will easily
accept pins. Be sure to use plenty of pins or weights when building in order to hold assemblies firmly in place.
When building over full-size plans, always protect them with wax paper to prevent glue damage and parts sticking to the plans
themselves.
When asked to mark on the parts themselves, do not use a ball point pen directly on the wood. Ink will invariably leach through
your film covering material and could ruin the finish. Use a well sharpened #2 pencil for best results. Use a small piece of
masking tape and a pen to identify each of the various laser cut parts. To do this, refer to the Key To Laser Cut Parts drawings.
Note that the outlines of the actual laser cut parts themselves have been purposely interrupted at various points. This must be
done to keep the parts in their appropriate sheets. Use a hobby knife and a sharp #11 blade to remove the parts from their
sheets as they are required for each step. All parts included in this kit can be easily identified in the COMPLETE KIT PARTS
LIST.