NL Troubleshooting
Malfunction
Cause and Troubleshooting
Loud noise during
spinning.
Device feet are not fixed.
▶
Secure the device feet. Adjusting the device
Transport protections have not been removed.
▶
Remove transport protections.
Clapping, clattering
in the pump.
A foreign object has entered the pump.
▶
"Cleaning the drain pump", page 39
Slurping, rhythmic
suction sound.
Pump is active, the solution is being pumped out.
▶
No error - normal operating noise.
wrinkling.
Spin speed is too high.
▶
Set a lower spin speed for the next wash.
The load quantity is too high.
▶
Reduce the load during the next wash.
Inappropriate program set for the type of fabric.
▶
Select a suitable program for the type of fabric.
Detergent or laundry detergent
softer drips from
the cuff and collects on
the door or in the cuff
fold.
Too much detergent/fabric softener in the detergent
drawer.
▶
When dosing the liquid detergent and fabric softener,
pay attention to the marking in the detergent drawer
and do not dose above that.
Spin result is
not to satisfaction-
ness. The laundry is
too wet / too damp.
Low spin speed is set.
▶
Set a higher spin speed for the next wash.
▶
Start the program Centrifuge.
Anti wrinkle is activated.
▶
Select a suitable program for the type of fabric.
Drain pipe or water drain hose is clogged.
▶
Clean the drain pipe and the water drain hose.
Drain pipe or water drain hose is kinked or
pinched.
▶
Make sure that the drain pipe and the water
drain hose are not kinked or pinched.
The unbalance detection system has interrupted the
spin cycle due to uneven distribution of the laundry.
▶
Redistribute the laundry in the drum.
50
Summary of Contents for WM6HXM71NL
Page 18: ...NL Set up and connect 2 Check the mains plug for tightness 18 ...
Page 59: ......