Troubleshooting NL
Malfunction
Cause and Troubleshooting
Washing water is not
pumped out.
▶
Resume the program by Centrifuge or Drain to
choose and press Start/Refill
too busy-
know.
"Resume program at rinse hold", page 33
Water drain hose is connected too high.
▶
Install the water drain hose at a maximum height of 1
meter.
Pump cover not assembled correctly.
▶
Assemble the pump cover correctly.
Detergent dosage is too high.
▶
Immediate measure: mix a tablespoon of fabric softener
with 0.5 l of water and pour this mixture into the left
compartment (not for outdoor, sportswear and down
textiles).
▶
Reduce the amount of detergent for the next wash
with an equal load.
Unauthorized extension mounted on the water drain
hose.
▶
Remove any unauthorized extensions from the
water drain hose. Connect device
Pump cover is not fully screwed in.
▶
Make sure that the pump cover is screwed into the
device as far as it will go. The pump cover handle
must be vertical.
No water flows into
the device. The
detergent was not
washed in.
Start/Refill
was not pressed.
▶
Press Start/Refill
.
Strainer in the water supply is clogged.
▶
Clean the strainer in the water supply.
Water tap is closed.
▶
Open the water tap.
Water supply hose is kinked or pinched.
▶
Make sure that the water supply hose is not
kinked or pinched.
Start several times
with centrifugation.
The imbalance control system eliminates the
imbalance by distributing the laundry several times.
▶
No error - no action required.
Remark: When loading, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
47
Summary of Contents for WM6HXM71NL
Page 18: ...NL Set up and connect 2 Check the mains plug for tightness 18 ...
Page 59: ......