Troubleshooting NL
Malfunction
Cause and Troubleshooting
strong foam
ming.
Detergent dosage is too high.
▶
Immediate measure: mix a tablespoon of fabric softener
with 0.5 l of water and pour this mixture into the left
compartment (not for outdoor, sportswear and down
textiles).
▶
Reduce the amount of detergent for the next wash
with an equal load.
High spin speed
rental is not
reached.
Low spin speed is set.
▶
Set a higher spin speed for the next wash.
Anti wrinkle is activated.
▶
Select a suitable program for the type of fabric.
Unbalance control system compensates for
imbalance through reduced spin speed.
▶
Redistribute the laundry in the drum.
Remark: If possible, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
▶
Start the program Centrifuge.
Program centrifugal
run does not start.
Drain pipe or water drain hose is clogged.
▶
Clean the drain pipe and the water drain hose.
Drain pipe or water drain hose is kinked or
pinched.
▶
Make sure that the drain pipe and the water
drain hose are not kinked or pinched.
The unbalance detection system has interrupted the
spin cycle due to uneven distribution of the laundry.
▶
Redistribute the laundry in the drum.
Remark: If possible, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
▶
Start the program Centrifuge.
fizzing, hissing
loud.
Water is flushed into the detergent drawer under
pressure.
▶
No error - normal operating noise.
Loud noise during
spinning.
The appliance is not leveled properly.
▶
Adjusting the device
49
Summary of Contents for WM6HXM71NL
Page 18: ...NL Set up and connect 2 Check the mains plug for tightness 18 ...
Page 59: ......
