en
Positioning and connecting
18
■
The mains plug must be freely
accessible at all times. If this is not
possible, in order to comply with the
relevant safety regulations, a switch
(2-pole switch-off) must be built into
the permanent installation in
accordance with electrical
installation regulations.
■
The mains cable is not bent,
squashed, modified, cut through, or
in contact with heat sources.
Before washing for the first
time
The washing machine has been
thoroughly tested before leaving the
factory.To remove any water that may
be left over from testing, run the first
wash cycle
without
any laundry.
Notes
■
The washing machine
must be
correctly
installed
and
connected
.
■
Never use a damaged machine.
Notify your after-sales service.
Preparatory work:
1.
Check the machine.
2.
Fill the
¨
and
M
dispensers.
3.
Remove the protective film from the
control panel.
4.
Plug in the mains plug.
5.
Turn on the tap.
Run the program without laundry:
1.
Switch on the appliance.
2.
Close the door (do not load any
laundry).
3.
Set the
O
чи
c
тка
барабана
(Drum
Clean)
90 °C
program.
4.
Open the detergent drawer.
5.
Pour approx. 1 litre of water into the
manual dosing compartment.
6.
Pour all-purpose detergent into the
manual dosing compartment.
Note:
To prevent foaming, only use
half the amount of detergent
recommended by the detergent
manufacturer.Do not use detergents
intended for woollens or delicates.
7.
Close the detergent drawer.
8.
Start the program.
9.
Switch off the appliance once the
program has finished.
Your washing machine is now ready to
use.
Transportation
E.g. when moving house
Preparatory work:
1.
Turn off the tap.
2.
Release the water pressure in the
3.
Disconnect the washing machine
from the mains power supply.
4.
drain pump is blocked, emergency
5.
Detach the hoses.
6.
Empty the dispensers.
Caution!
Risk of damage to the appliance
caused by detergent/fabric softener
leaking from the dispensers
Leaking detergent/fabric softener
can prevent the appliance from
working correctly, e.g. due to
damage to the electronics.
Empty the dispensers before
transporting the appliance.
