Siemens WM T Series, Instruction Manual And Installation Instructions

Page: 39 / 54

Intelligent dosing system
en
39
Check whether the preset basic
dosages follow the manufacturer's
recommendations in terms of:
■
A 4.5 kg load
■
For liquid detergent – the
normal
degree of soiling and the relevant
water hardness
■
For fabric softener – the
medium
softness
Refer to the packaging label on your
liquid detergent/fabric softener or ask
the manufacturer directly for this
information.
Below is an example of detergent
dosages on a packaging label:
If necessary, adjust the basic dosages
to the recommended load for the liquid
detergent/care product you are using,
the water hardness and/or the degree
of soiling.
Adjusting the basic dosage
1.
Press and hold
‰
i-Dos and/or
Â
i-Dos for approx. 3 seconds.
The basic dosage setting will be
displayed.
2.
Change the setting using:
˜
/
~
3.
To exit setting mode, press and hold
‰
i-Dos and/or
Â
i-Dos for
approx. 3 seconds or wait approx.
10 seconds.
Notes
■
The changes are applied to all
programmes in which dosing is
possible.
■
The changes are saved until the next
time they are changed and are
retained even after the appliance has
been switched off.
Filling the dispensers
Notes
■
See the instructions in chapter
~
"Before setting up i-Dos"
on page 37
■
If
¨
or
M
flashes, fill the relevant
dispenser.
~
Page 37
Fill the dispensers as follows:
1.
Pull out the detergent drawer.
2.
Open the dispenser lids.
3.
Pour liquid detergent and fabric
softener into the relevant dispensers.
Notes
– Do not fill the dispensers above
the
max.
mark.
For standard load
4 - 5 kg
Level of soiling
light normal heavy
Water
hardness
soft/
medium
40 ml 55 ml 80 ml
hard/
very
hard
55 ml 80 ml 105 ml
In this example, a basic dosage of 55 ml must be
set for a medium water hardness.