en
Faults and what to do about them.
46
The drain hose at the siphon
is blocked
1.
Switch off the appliance. Pull out the
mains plug.
2.
Loosen the hose clamp. Carefully
remove the drain hose; residual
water may leak out.
3.
Clean the drain hose and siphon
connecting piece.
4.
Re-attach the drain hose and secure
the connection point using the hose
clamp.
Filter in the water supply
blocked
1.
Release water pressure in the supply
hose:
a) Turn off the tap.
b) Select the Cottons programme.
c) Start the programme and leave it
to run for approx. 70 seconds.
d) Switch off the appliance.
e) Pull out the mains plug.
2.
Clean the filters:
a) Disconnect the hose from the
water tap.
Clean the filter with a small brush.
b) For standard and Aqua-Secure
models, clean the filter on the
rear of the appliance:
Remove the hose from the rear of
the appliance.
Use pliers to remove the filter and
then clean it.
c) Connect the hose and check for
leaks.
3
Faults and what to do
about them.
Faults and what to do about them.
Emergency release
E.g. in the event of a power cut
The programme continues when the
power supply is restored.
However, if the laundry has to be
removed, the washing machine door
can be opened as follows:
:
Warning
Risk of scalding!
When you are washing at high
temperatures, there is a risk of scalding
if you come into contact with hot water
and laundry.
If possible, leave it to cool down first.
:
Warning
Risk of injury!
You may injure your hands if you reach
into the drum while it is turning.
Do not reach into the drum when it is
turning.
Wait until the drum has stopped turning.
