05.2006
Parameterizing Steps
Siemens AG
6SE7087-2JD60
SIMOVERT MASTERDRIVES
Operating Instructions
9-3
9.1
Parameter reset to factory setting
The factory setting is the defined initial state of all parameters of a unit.
The units are delivered with this setting.
You can restore this initial state at any time by resetting the parameters
to the factory setting, thus canceling all parameter changes made since
the unit was delivered.
The parameters for defining the power section and for releasing the
technology options and the operating hours counter and fault memory
are not changed by a parameter reset to factory setting.
Parameter number
Parameter name
P050 Language
P070
Order No. 6SE70..
P072
Rtd Drive Amps
P073
Rtd Drive Power
P366 Select
FactSet
P947 Fault
memory
P949 Fault
value
Table 9-1
Parameters which are not changed by the factory setting
If the parameters are reset to the factory setting via one of the
parameters (SST1, SST2, SCB, 1.CB/TB, 2.CB/TB), the interface
parameters of that interface are not changed either. Communication via
that interface therefore continues even after a parameter reset to the
factory setting.
Parameter number
Parameter name
P053 Parameterization
enable
P700
SST bus address
P701
SST baud rate
P702
SST PKW number
P703
SST PZD number
P704
SST frame failure
Table 9-2
The factory setting is made either via interface SST1 or SST2:
Parameters that are not changed by the factory setting either.
None
of
the indices of the parameters is changed.
