Applications
9.2 Parallel connection for redundancy
SITOP PSU8200/3800 3ph
Manual, 05.2018, C98130-A7638-A1-6-7629
95
9.2
Parallel connection for redundancy
Connecting several 24 V power supplies in parallel for redundancy purposes is required if
especially high demands are placed regarding the availability of a reliable 24 V power supply.
Using the SITOP PSE202U redundancy module, two power supplies of the same type up to
20 A can be decoupled (Figure 9-2 Redundant configuration with two power supplies and
SITOP PSE202U redundancy module (Page 95)). When one of the devices fails, then the
other automatically takes over the power supply. If one of the power supplies fails, then this
is signaled using an LED on the redundancy module as well as an isolated relay contact.
For higher output currents, each power supply must be connected to a redundancy module
(Figure 9-3 Redundant configuration with two power supplies and two SITOP PSE202U
redundancy modules (Page 95)). When dimensioning the system, it must be ensured that
n+1 redundant connected power supplies can handle the total power requirement of the
remaining n power supplies.
Note
For a high reliability of the supply, it is recommended that the redundant switched power
supplies are fused separately on the line-side and, if possible, be connected to different line
supplies.
Figure 9-2
Redundant configuration with two power supplies and SITOP PSE202U redundancy
module
Figure 9-3
Redundant configuration with two power supplies and two SITOP PSE202U redundancy
modules
