7 Power supply system SITOP PSU8600
Integration of a SITOP 24V power supply in PCS 7
Entry ID: 10948108, V3.2, 01/2019
57
S
iem
e
n
s A
G
2
0
1
9
A
ll r
igh
ts
re
se
rv
e
d
7.1
Setting up the hardware configuration
You configure the AS and the external peripherals according to the PCS 7
standard. To configure the power supply system, the corresponding GSD must be
installed.
You can find the Generic Station Description (GSD) in the entry "GSD for SITOP
PSU8600 for integration in SIMATIC STEP 7" at the following link:
https://support.industry.siemens.com/cs/ww/en/view/102254061
Parameterizing Ethernet nodes
The SITOP PSU8600 communicates by means of PROFINET IO on the
automation system’s fieldbus. f you have not already done so, you must first adapt
the IP address and the device name of the PSU to the network configuration of the
fieldbus.
Note
To parameterize the Ethernet nodes, they must be on the same physical network
as the ES. After this, you can make the separation between the plant bus and
the process bus (field level).
Proceed as follows:
1. Make sure that the device is on the same physical network as the configuration
computer.
2. In the SIMATIC Manager, execute the menu command "Target system > Edit
Ethernet Node".
3. In the "Edit Ethernet Node" dialog, click on the "Browse" pushbutton (1) in the
"Ethernet Node" area.
4. In the "Browse Network" dialog, choose the PSU8600 from the list of nodes
and click on "OK" to confirm your selection.
5. Edit the IP address to match your network configuration and click on the
"Assign IP Configuration" pushbutton (2).
6. Edit the device name and click on the "Assign Name" pushbutton (3).
7. Close the dialog again.
