SIREMOBIL Iso-C 3D
SPR2-230.814.01
Page 2 of 14
Siemens AG
Rev. 05
08.04
CS PS 24
Medical Solutions
4 - 2
Kapitelüberschrift hier eintragen
•
Move the C-arm into the 0º position (Fig. 1).
•
Apply marks at 20 mm intervals to determine the lateral limit for the cam (Fig. 2).
•
Position the cam. Ensure that the cam is flush with the top and mark the holes with the
cams laterally at the 20 mm mark (Fig. 3).
•
Punch-mark the holes.
•
Ensure that shavings or dust do not drop into the C-arm.
•
Use a 3.2 mm bit for drilling. Continue until you have have drilled through the wall.
Ensure that you are not drilling beyond the wall (Fig. 4).
•
Counterbore the holes.
•
Cut the threads using an M4 thread tap (e.g. use a tap wrench) (Fig. 5).
•
Attach the cam using 2 countersunk screws M 4 x 8 (Fig. 6).
•
Repeat these steps on the other side of the C-arm.
Fig. 5
Cutting the threads
Fig. 6
Attaching the cam