RF-MANAGER RF310M software
9.1 Prerequisites for working with the RF-MANAGER RF310M software
SIMATIC RF310M Mobile Reader
62
Operating Instructions, 10/2013, J31069-D0191-U001-A6-7618
Example 2
1.
Select "Start > Programs > Summit > SCU" in the mobile reader.
2.
Click on the "Profiles" tab.
3.
Select the "New" button to create a new profile setting
4.
Enter a name for the profile setting.
5.
At least make the following settings:
–
SSID (name of the radio network), e.g. "RF310M"
–
Auth Type (security level): e.g. "Shared"
6.
Select the encryption required under "Encryption": e.g. "WPA2 PSK".
7.
Then click the button "WEP keys/PSKs". Enter the encryption code and confirm with
"OK".
8.
Click the "Commit" button to confirm the settings.
9.
In the "Main" tab, under "Active config", select the profile that should be active.
10.To activate these changes, change to the device to the "Powerdown" mode by pressing
the blue <FN> key and the on/off button at the same time for approximately 7 seconds.
The device then restarts.
Note
Other encryption possibilities
You can also use other encryption methods, depending on the access point. "WEP"
encryption is no longer regarded as secure; you should not use this.
9.1.6
Enter the IP address in the mobile reader
If a DHCP server is not present in the network, you must enter the IP address of
SIMATIC RF310M in the SIMATIC RF310M mobile handheld terminal:
1.
Double-click the WLAN icon in the taskbar for this purpose.
2.
In the "IP Information" tab, click the "Configure" button and select "Specify an IP
address". Enter the IP address.
As an alternative, you can also enter the IP address as follows:
1.
"Start > Settings > Control Panel > Network and Dial-up Connections" and select the
relevant connection.
2.
In the "IP Information" tab, click the "Configure" button and select "Specify an IP
address". Enter the IP address.
