Mounting/Extending
6.1 Installing the device
SIMATIC PN/J1939 LINK
34
Operating Instructions, 12/2018, A5E45307564-AA
Mounting to a control panel
Proceed as follows:
1.
Drill holes (M4). The dimensions for the drill holes are available in the figure below.
2.
Move the sliders
①
to the outside until they latch in place.
3.
Fasten the module with a cylinder head screw M4 as well as a spring lock washer and a
flat washer.
Note
Do not use a countersunk head screw.
The type of screw required depends on the type of material on which the module is
mounted. Fasten the screw with the corresponding torque until the spring lock washer is
pressed flat.
Do not fasten the screws with excessive torque.
Figure 6-2
Control panel mounting of the PN/J1939 LINK
Summary of Contents for SIMATIC PN/J1939 LINK
Page 1: ...SIEMENS siemens com ...
Page 2: ......
