Siemens SIMATIC NET SCALANCE M80PB, Getting Started

Page: 28 / 62

PROFIBUS connection
2.2 Remote service
Cloud Connector
28
Getting Started, 07/2020, C79000-G8976-C507-03
2.2.3 Configuring SINEMA RC and TIA Cloud Connector on the device
Requirement
• SCALANCE M804PB has been created on the SINEMA RC.
• The SINEMA RC certificate is imported into the SCALANCE M804PB.
Procedure
1. Click "System > SINEMA RC" in the navigation area.
2. Configure the SINEMA RC with the following settings:
SINEMA RC address IP address of the SINEMA RC server
SINEMA RC port 443
Verification type: CA certificate
CA certificate The imported CA certificate
Device ID The device ID is created automatically when the device is created
in the SINEMA RC server.
Device Password
Device Password Confirmation
The password configured for access.
Auto Firewall/NAT rules The firewall and NAT rules are created automatically for the VPN
connection. The connections between the configured exported
subnets and the subnets that can be reached via the SINEMA RC
server are allowed. The NAT settings are implemented as config-
ured in the SINEMA RC server.
You can enable SINEMA RC to access specific services of the de-
vice under "Security > Firewall > Predefined IPv4".
Type of connection Permanent
3. Select "Enable SINEMA RC" and click the "Set Values" button.
4. Click "System" > "Cloud Connector" in the navigation area.
5. Configure the TIA Portal Cloud Connector with the following settings:
Operation Enabled
Port 9023 (default port)
Protocol PROFIBUS
6. Click the "Set Values" button.