Expanding and assigning parameters to the device
6.6 Drives
SIMATIC IPC847E
118
Operating Instructions, 10/2018, A5E43920357-AA
6.6.3
Change 2.5" and 3.5" drive in assembly kit for 5.25" tray
You can find information on the correct mounting location for drives with a assembly kit for
type A drive cage in "Permissible expansion for temperature range 0 to 40 °C (Page 100)"
and "Permissible expansion for temperature range 0 to 50 °C (Page 102)", for type B drive
cage under "Permissible expansion for temperature range 0 to 40 °C (Page 114)" and
"Permissible expansion for temperature range 0 to 50 °C (Page 116)".
NOTICE
Risk of damaging the drive and data loss
When you remove the drive while data is being written to it, you may damage the drive and
destroy data.
•
Only remove the removable tray from the device when the drive is inactive, see "Status
displays on removable tray for drives (Page 28)".
•
Observe the ESD guidelines.
Requirement
●
An original spare part, i.e. an "Assembly Kit HDD/SDD for 5.25" tray" approved for this
device.
●
If there is no RAID system: The device is fully disconnected from the line voltage, see
"Switching off the device (Page 60)".
●
The device is open, see important information in "Open the device (Page 89)".
●
When replacing an HD: T10 screwdriver
●
When replacing an SSD: T8 screwdriver
