Siemens Simatic ET 200pro FC, Operating Instructions Manual

Page: 138 / 196

Series commissioning and operation
8.1 Transfer of the frequency converter parameter assignment
ET 200pro FC
138
Operating Instructions, 07/2016, A5E01100763B AC
8.1.5 Parameter transfer with PLC
Parameters can be uploaded and downloaded via fieldbus using the transfer mechanisms of
data set 47. For detailed information, refer to "Commissioning and Optimization".
8.1.6 Fault codes during upload and download
Fault codes
If a fault occurs during an automatic download procedure, the frequency converter returns to
the parameter set that was previously stored in the EEPROM and the following fault codes
are generated:
Error Cause Remedy/Test
F00061 No MMC inserted
• MMC faulty?
•
Insert an MMC and attempt the upload/download
again.
F00062 MMC contents invalid
•
MMC faulty?
•
Parameter valid for this frequency converter?
F00063 MMC contents incompatible
•
MMC faulty?
• Parameter set clone00.bin available on the MMC
•
Parameter valid for this frequency converter?
F00395 Different application ID after download See below
Note
Once parameters have been uploaded from and downloaded to different frequency
converters, the parameter settings must be checked.
Downloading parameters from another frequency converter may cause a fault to occur with
F00063 output, if there are parameters that cannot be downloaded (check P0949 regarding
the (first) parameter number that cannot be downloaded).
If fault code F00061 or F00063 occurs during startup, it can only be cleared by shutting down
and restarting.