Siemens SIMATIC C7-626, Installation, Assembly, Wiring

Page: 120 / 144

A
A-6
C7-626 / C7-626 DP Control Systems
C79000-G7076-C626-01
A.3 Notes for the Machine Manufacturer
The SIMATIC programmable controller system is not a machine as defined in
the EU Machinery Directive. There is therefore no declaration of conformity
for SIMATIC with regard to the EU Machinery Directive 89/392/EEC.
The EU Machinery Directive 89/392/EEC regulates requirements relating to
machinery. A machine is defined here as an assembly of linked parts or
components (see also EN 292-1, Paragraph 3.1).
SIMATIC is part of the electrical equipment of a machine and must therefore be
included by the machine manufacturer in the declaration of conformity
procedure.
The EN 60204-1 standard (Safety of Machinery, Electrical Equipment of
Machines, Part 1, Specification for General Requirements) applies for electrical
equipment of machinery.
The table below is designed to help you with the declaration of conformity and
to show which criteria apply to SIMATIC according to EN 60204-1 (as of June
1993).
EN 60204-1 Subject/Criterion Remarks
Paragraph 4 General requirements Requirements are met if the devices are mounted/installed in
accordance with the installation guidelines.
Please observe the explanations on the previous pages.
Paragraph 11.2 Digital input/output
interfaces
Requirements are met.
Paragraph 12.3 Programmable equipment Requirements are met if the devices for protection of memory
contents against change by unauthorized persons are installed in
locked cabinets.
Paragraph 20.4 Voltage tests Requirements are met.
Introduction
EU Machinery
Directive
89/392/EEC
Electrical
Equipment of
Machinery in
Accordance with
EN 60204
General Technical Specifications